Gear Oil Pump with Oil Transfer Gear Pump

Basic Info

Model NO.	KCB
Certification	CE
Series	KCB
Transport Package	Wood Box
Specification	CE
Trademark	liansheng or OEM
Origin	Shanghai, China
HS Code	84101330
Production Capacity	50000

Product Description

Products name: Gear Oil Pump with oil transfer gear pump

Conditions of use:

1. KCB type gear oil pump for lubrication of a liquid conveying, the temperature is not higher than 70

celsius, for high temperature 200 celsius, with the units can be equipped with high temperature resistant

materials, viscosity of 5 × 10-5 ~ 1.5 × 10-3m2/S.

2. The pump is not suitable for conveying corrosive, containing hard particles or fibers, height volatile or

lightning low liquid, such as gasoline, stupid.

Product use:

1. Gear pumps are widely used in chemical, petroleum, metallurgy, light industry, synthetic fiber,

environmental protection, food, medicine and other departments.

2. This kind of product is stable and reliable performance, good sealing performance, handsome in

appearance, convenient operation and other advantages. In order to improve the product quality, reduce

the run, run, drip, leak, to prevent pollution, improve the environment, play a big role.

fault phenomenon	failure cause	elimination methods
	1.No power supply or one or two phase power supply is needed	Check all phases of power supply and restore power supply
	2.Poor contact of ac contactor and burning of coil	Repair or replace contactors
can not start	3. The power switch is not closed, malfunction or damaged	Close the switch and replace it if the power indicator does not turn on
	4. Thermal relay trip or damage	Check whether the motor is blocked, find out the reason and eliminate it.Manual reset is replaced if it cannot be started
	Water level is too low	Put water in the sink
	The motor burned	Repair or replace the motor
	1.Line is loose	Check wiring and tighten connectors
	2.Frequency converter malfunction	Check the fault content, check the cause according to the frequency converter manual, and restart after reset.Or disconnect the inverter power supply for a few seconds, the inverter fault reset before starting.
The manual is normal	3The frequency converter is damaged	Repair or replace
Automatic transmission failure	4.Pressure switch damage	Repair or replace
	5The pressure transmitter is damaged	Repair or replace
	6.Switch failure	Repair or replace
Pump non - suction pressure gauge pointer to beat violently	Insufficient water supply for perfusion, air leakage at the connection between pipeline and instrument	Check pipeline and bottom valve, refill water diversion. Tighten air leakage
The pump consumes too much power	Too much flow, impeller wear	Check whether the pump shaft is bent, replace the impeller, close the outlet valve to reduce the flow